Quality Lock (Mold-in Inserts)

This is a revolutionary type of insert nut with a square groove in the middle.
Compared with conventional inserts with diamond knurling, the strength is significantly increased.
No cutting dust is generated, thus improving the quality.
Major Insertion Method
Mold-in Insertion
Material
Brass (C3604), Aluminum Alloy (made-to-order)

■ Features

・ Revolutionary type of insert with a square groove in the middle
・ In favourable conditions, the strength of this product will be doubled more than the strength of conventional inserts with diamond-shaped knurling
・ Non-orientation design for higher productivity and workability
・ No cutting dust is generated even during transportation, thus improving quality
・ Full compliance with RoHS Directive

■ Dimensions

Quality Lock Dimensions
Three-dimensional Drawing
クオリティーロック® 寸法図
クオリティーロック®寸法図
立体図
クオリティーロック®立体図
品 番
ね じ
A
B
C
ローレット段数
樹脂下穴径(参考値)
 
CS3.3ーM2-2.0
M2×0.4
3.30
2.00
3.00
1
φ3.05
Part Number
Thread and Pitch
A
B
Hole size before threading
 
QL-M2-3.0
M2×0.4
3.20
3.00
min 1.567
max 1.679
QL-M2-4.0
M2×0.4
3.20
4.00
min 1.567
max 1.679
QL-M3-3.0
M3×0.5
5.00
3.00
min 2.459
max 2.599
QL-M3-4.0
M3×0.5
5.00
4.00
min 2.459
max 2.599
QL-M3-5.0
M3×0.5
5.00
5.00
min 2.459
max 2.599
QL-M4-4.0
M4×0.7
6.50
4.00
min 3.242
max 3.422
QL-M4-5.0
M4×0.7
6.50
5.00
min 3.242
max 3.422
※ Standard parts    Unit.mm

■ Quality Lock Performance (Reference)

Size
Pull-out(N)
Jack Torque(N-m)
Plastics
QL-M2-3.0
620
0.41
ABS
Diamond Knurling M2 (Length: 3.0 mm)
520
0.29
ABS
QL-M3-3.0
1,008
1.22
ABS
Diamond Knurling M3 (Length: 3.0 mm)
810
0.91
ABS
QL-M4-5.0
2,010
2.61
ABS
Diamond Knurling M5 (Length: 5.0 mm)
1,100
1.28
ABS
※ The strength largely depends on the plastic to be used. It should be tested in advance.
1N≒0.098kgf
1N-m≒9.8kgf-cm
■ NOTE
・ Headed inserts are also available.
・ Please contact us if you need Pb-free material for environmental reasons.
・ Choose the die pin diameter based on the dimension of the hole size before threading.
・ The diameter of the pilot hole for the mounting object should be smaller
  than the outer diameter of the insert (Dimension A) if possible.
・ When inserts are tightened by screws, choose the screw length so that screws
  do not reach the bottom of insert pilot holes.
・ The specifications are subject to change without notice.
・ Please contact us if you have any other questions.

製品一覧から選択