Insert nut's test strength service
Upon receiving insert nut sample from customers, we will use plastic (pellet) to run tests on the insert nut sample by using the injection molding process of our company. According to the test results, we could determine shape and strenght of product using for mass production.
Flow of testing service
STEP1 Briefing
Briefing on the details of insert nut and kind of plastic material required for testing.
STEP2 Sending Quotation
We will send the quotation and terms of testing service.
STEP3 Supply testing material
Please provide us materials that using for testing, such as pellet of plastic. ( Weight = Min )
STEP4 Moulding
We will test your material by using injection moulding process。( We will use mold-in for Insert nuts for simultaneous molding )
STEP5 Insert
In case of installation after molding, we need to have a discussion about the insert condition, so we can be sure the test insert installation going on the right direction.
STEP6 Testing operation
We will begin testing on pull out strength, torgue, as well as completing samples from insert nut test.
STEP7 Resending testing data and bill
We will send back testing data and bill for customer.
NOTE
・This is fee-for-servive.
・This service only available to customers who purchase insert nut product from our company.
・Depending on the conditions of plastic and nut, there are some cases we cannot provide this testing service.
・Test result is for reference only and does not guarantee product strength in mass production. It is up to the customers to use this result or not.
・Please contact us if you have any other questions.
・This service only available to customers who purchase insert nut product from our company.
・Depending on the conditions of plastic and nut, there are some cases we cannot provide this testing service.
・Test result is for reference only and does not guarantee product strength in mass production. It is up to the customers to use this result or not.
・Please contact us if you have any other questions.