Technical terms related to plastics (H line)

  • Biomass plastics
  • burr (e.g. on a machined edge)
  • sink mark
  • pellet
  • Electrical discharge machining
  • Polymers & Polymer Alloys


Biomass plastics


Biomass plastics are plastics made from biomass (biological resources).
Biomass is defined as organic resources derived from living organisms (excluding fossil resources) that are renewable, and is carbon neutral.
In addition, many biomass plastics are biodegradable, meaning that they can be decomposed by microorganisms and recycled into raw materials for biomass plastics.




Burr


A burr is a hardened part of the material that enters the gap between molds during the molding process.
They are basically superfluous parts and are removed before the finished product is produced, but sometimes burrs remain due to problems in manufacturing technology, etc., and are a factor that reduces the value and performance of the product.




Flaws


A crack is a depression caused by shrinkage during plastic molding.
When plastic is molded, it is fluidized at a high temperature and then cooled to solidify. During the cooling process, there is a difference in the cooling speed between the inside and outside of the plastic (generally, the inside of the product cools more slowly than the outside).
In most cases, this problem tends to occur when manufacturing thick plastic products, and is often dealt with by holding pressure or overfilling with resin.
If the material is highly rigid, the surface of the material will not deform easily due to internal shrinkage after it has cooled and hardened, resulting in internal voids.




Pellet


A raw material for plastic.
In general, thermoplastics are sold in small spherical or cylindrical pellets.




Electrical discharge machining


This is a method of machining using electrical discharge energy.
In general, thermoplastics are commercially available in small spherical or cylindrical pellets.



Polymers and polymer alloys


A polymer is a high-molecular compound produced by the repeated polymerization of monomers.
Polymers are high-molecular compounds produced by repeated polymerization of monomers.
By combining multiple types of polymers, it is possible to create plastics with new properties, and is used as a method to develop "engineering plastics.